Crumpet version 2 クランペット 第二弾

After we made blini using a newly rediscovered cast iron pan (supposedly called a "platar"), we challenged ourselves to use it to make crumpets. The last attempt at crumpets was less than successful; those crumpets did not develop the "hole-y" characteristic which makes a crumpet crumpet. This time with a new recipe and the newly rediscovered cast iron pan, we succeeded in making perfect crumpets. We served them with melted butter and a small amount of honey.

The batter is rather runny almost the consistency of pancake batter. In our previous version we used English muffin rings, as recommended in the recipe we were using, but the batter seeped out at the bottom of the ring. We had no such problem with our cast iron pan.

The new recipe had instructions as to how to control the heat to develop multiple holes as shown in the second and third pictures. You can see that while cooking, bubbles developed and then popped creating nice holes.

Ingredients:

1 times the recipe (about 14 crumpets)
300 g. (2 cups) AP flour
400 ml. (1 1/2 cups) warm water
1 tsp. Salt
1 tsp. Sugar
2 tsp. Baking powder (The recipe said baking soda doesn’t work as well)
2 tsp yeast
2 tbs. warm water

1 1/2 times the recipe (about 21 crumpets)

3 cups AP flour (2 cups AP and 1 Cup +2 Tbs. Cake flour) 

600 ml. warm water
1 1/2 tsp. Salt
2 tsp. Sugar
3 tsp. Baking powder (The recipe said baking soda doesn’t work as well) 
3 tsp yeast
3 tbs. warm water

2 times the recipe (this is the recipe I’ve been using) 
600 g. (4 cups) AP flour (or 2 cups AP and 2 cups + 1/4 cup  Cake flour) 
800 ml. (3 cups) warm water (or buttermilk or regular milk)
2 tsp. Salt
2 tsp. Sugar
4 tsp. Baking powder (The recipe said baking soda doesn’t work as well) 
4 tsp yeast
4 tbs. warm water (1/4 cup)

(Use second to largest scoop not completely filled)

Directions:
Bloom the yeast in the warm water. Put the flour, water and salt in the bowl of an electric mixer and beat on speed 5 for 1 minute until smooth paste forms. Add the yeast mixture, sugar and baking powder and mix on speed 5 for another 30 seconds. Cover with cling wrap and put in a warm place for 15 to 30 minutes. The surface should get foamy but it will only increase in volume by 10 to 15 %.

Pre-heat the platar and coat the cups with melted butter. Using a small ladle scoop the batter into the cups. Heat control is key to crumpet success. Stronger heat is needed to begin with to get the holes bubbling. Cook on the higher heat for about 1 1/2 minutes until bubbles start appearing. Then lower the heat so the crumpet cooks through without burning the base, but strong enough to make the bubbles pop. Cook on the lower heat for about 1 minute until the bubbles start popping. Bubbles will start to pop around the edges first then in the center. Finally, lower the heat further and continue cooking for 2 1/2 to 4 minutes until the surface is set and it is clear no more bubbles will be popping. (According to the recipe, at this stage the final bubbles could be popped with the help of a skewer.)  Some wisps of smoke from the butter around the rings may appear. If there is a lot of smoke it means the skillet is too hot. Flip them over to cook the other side for 20 to 30 seconds to give it a blush of color. Cool on a wire rack. 

These crumpets were much better than the first batch we made. They got even better after the second day. We tasted them just out of the pan and the outside was crunchy but the inside was kind of wet and doughy. We initially thought they may not have been cooked through. But by the next day the insides had firmed up and were nicely chewy. The flavor was nicely accented with the taste of browned butter. We toasted them in the toaster oven and served them with melted butter and some honey. Mighty fine!